Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
I then put the milled lightening cuts into the water table. I used a 3/8" ball end mill. The cuts are. .10" deep. Then the serial number was re stamped in the left rear cut. I did not stamp a grade number since I am not really "cloning" a particular grade.
Threaded Mode