Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
The floor plate might tighten up. I fear the cocking slide is not aligned. The best bet is to remove the floor plate (be careful of the trip sping and pin under the cocking lever) and place the cocking slide in correct psition then replace the floor plate. The barrels will come off once the floor plate and cocking slide are off the gun. Again, be careful of the trip, spring and pin.
Threaded Mode