Linn, I assume that you are attempting to lower the point of impact ? If your stock is in the range of normal drop measurements, changing the dah may not acomplish what you want. the degree of pitch has a direct effect on lowering or raising point of impact. I would suggest spacing out the plate or pad, one quarter of an inch at the top. This is easily acomplished by backing out the screws and placing three or four standard hardware washers between the plate and stock, snug down the screws and pattern the gun. I think you will be suprised at the results.If this works, then have a competent smith change the pitch. I don't recommend bending a parker stock, they will eventually crack.
Brad
|
Threaded Mode