Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Welcome & enjoy!
To read the Posts, Messages & Threads in the PGCA Forum, you must be REGISTERED and LOGGED INTO your account! To Register, as a New User please see the Registration Link Above. If you are registered, but not Logged In, please Log in with your account Username and Password found on this page to the top right.
Dean,
It was not a remington gun and it did not have any repair codes.
The border was spaced a bit too far away from the pattern to be correct for Remington era guns.
Tom,
I use a combination of two different comercially available checkering tools to cut the Mullered borders. One pass to lay out the guide lines and then a second to put the dish down the center.
Threaded Mode