Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Welcome & enjoy!
To read the Posts, Messages & Threads in the PGCA Forum, you must be REGISTERED and LOGGED INTO your account! To Register, as a New User please see the Registration Link Above. If you are registered, but not Logged In, please Log in with your account Username and Password found on this page to the top right.
I've advanced to a frame held carpenter's hand saw used for fitting mouldings around the perimeter of interior rooms. My hull holders are now uniform no matter the length needed. I'm able to cut both 12 and 16 gauge hulls - either plastic or paper - to very close uniform lengths. Now that I've got the method down, I have to figure out how to sell off those that have tumbled off the saw and been finished into hull trimming devices.
Threaded Mode