|
 |
 |
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
 |
 |
01-13-2010, 04:14 PM
|
#3 | ||||||
|
David: For all screws, use hollow ground driver tips that fit the entire slot side to side and edge to edge and full depth. That is very important in order to not end up with messed up screw heads. Clean the slot fully of any crud/rust/debris first. Apply minimal torque. If the screw does not turn, use a drop or two of penetratiing oil. Let it work for a while then try minimal torque again. Eventually, you win and have intact screw. Lose your patience and you lose the screw head. In the case of the trigger guard screw head, you are dealing with a wood screw so it should come out readily enough. The trigger guard screw that threads into the floor plate may need a bit of penetrating oil or may turn fairly easily. Good luck
Jack
__________________
Hunt ethically. Eat heartily. Last edited by Jack Cronkhite; 01-13-2010 at 04:50 PM.. |
||||||
|
|
||||||
 |
 |
 |
|
|
|
01-14-2010, 10:16 AM
|
#4 | ||||||
|
David, as a hunter, and shooter, NOT a collector, before you have that stock reinleted, ect.... I'd find out what it's dimentions are. If you havent been fitted, I'd do that. If your measurements arent even close to what the gun is, I'd restock. There are resonable stockers out there. No point in spending a dime on stock work that isn't going to work for YOU. Specially as its a non original.
I recently picked up a vh 16 O frame with a rough stock. It will be getting a new stock. the required repairs and possible bend to make it shootable, by ME will make a sizable dent in a stock job. Tim |
||||||
|
|
|
||||||
|
|
|
|
|
|
01-14-2010, 10:19 AM
|
#5 | ||||||
|
BTW I'm jelious. Dean, Dave and Dunkel have lit the damascus small gauge flame under my ass, and I'm looking for someting like you have for a "project".
I was so happy shooting nice Italian o/u's  now this old gun thing has reared it's ugly head, again
|
||||||
|
|
|
||||||
|
|
|
|
|
|
01-14-2010, 10:33 AM
|
#6 | ||||||
|
Enjoy the ride Tim.....
__________________
"Much care is bestowed to make it what the Sportsman needs-a good gun"-Charles Parker |
||||||
|
|
|
||||||
|
|
|
| The Following User Says Thank You to Dave Suponski For Your Post: |
 |
|
|
Hybrid Mode