Standardized Shotshell dimensions.

[edgarspencer]

Originally Posted by Dean Romig

But was Hayes’ rim cutter made to the later wider size?

Next time I see him, I'll ask. I do know that I loaned to another member who reported back that it was perfect. I do not believe there was a "later wider size" but do know that early rim recesses were shallower.

Yes Bill, I was looking at new ones in Clymers catalog. Like the Hayes tool, the Clymer tool is Just for cutting the rim recess. It is not a chamber reamer.

[Bill Murphy]

The one I used, whether it was a Clymer or a Manson, cut all the way up, including the rim recess. It was a very light cut on the forcing cone, didn't take any metal off my cones.

[Pa SxS]

The DH I used to have 1903 (see Avatar) would have trouble closing on new shells and if it would close, would be verry difficult to open. Some different manufacturers new shells would work just fine, some not. The problem seemed to be the brass rim. If there was a slight radius between the wall and rim, it wouldn't seat right. If it was almost a 90 degree angle, they worked fine. I had the rim cut worked on by Dewey.

I'm way to young to know about those planes.