Quote:
Originally Posted by charlie cleveland
wish you had got that reloader...i know they used the mec 600 10 ga reloader for a platform and made a 8 ga reloader out of it...but i hear it was a pretty costly affair...i get by with a homemade rezizer and ahand press and a old lee 10 ga hand reloader...i then use the precision roll crimper or the hand crimper....on that water solution for the top of the over shot card you cannot hold pressure on the wad while it set up..it takes a few hours to set up were as the hot glue only takes a few moments to set up...thus wad has some pressure on it so it goes bang better on the brass hulls....charlie
|
The reloader was actual a PGCA members I was able to find the page for it .
Looked like a pretty clean setup .
Im curious to see when RST releases their 8 ga loads how they resize the hulls .
Usually their are marks on the hulls after resizing . The 8 ga loader i seen the hulls didnt have any resizing marks on them they looked clean and neat .
Threaded Mode