|
 |
 |
||||||||||||||||||||||||||||||||||||||
Visit Brian Dudley's homepage! | | ||||||||||||||||||||||||||||||||||||||
 |
 |
03-13-2017, 01:30 PM
|
#13 | ||||||
|
Never bothered with a letter
|
||||||
|
|
||||||
 |
 |
 |
|
|
|
03-13-2017, 03:45 PM
|
#14 | ||||||
|
Then I would suspect the originality of it. But that is just me.
__________________
B. Dudley |
||||||
|
|
|
||||||
|
|
|
|
|
|
03-13-2017, 04:09 PM
|
#15 | ||||||
|
Parker Bros. single selective trigger was in the right trigger slot with the fore & aft sliding selector in the left trigger slot. The Hunter Arms Co. HOT and the A.H. Fox Gun Co. Fox-Kautzky single selective trigger were in the left barrel slot with the fore & aft sliding selector in the right trigger slot.
34891 01 Fox-Kautzky Single Selective Trigger.JPG So, a Parker Bros. SST replaced with double triggers would have the R and L on the left side of the triggers while on a Fox they are on the right. 374152 04.jpg During the early years of the NID, Ithaca Gun Co. used a Miller single selective trigger with the selector by movement of the safety slide fore or aft -- 457534 01.JPG 457534 02.jpg The only selector I could ever use when a bird is taking wing. The Howland Single Selective Trigger used by Ithaca in the later NID years externally looked the same. The Howland single non-selective trigger was in the left slot with a blank (?) in the right slot that lifts when the trigger is pulled. 461815 01.JPG |
||||||
|
|
|
||||||
|
|
|
| The Following 3 Users Say Thank You to Dave Noreen For Your Post: |
|
|
|
03-18-2017, 07:57 AM
|
#16 | ||||||
|
After getting a letter on the gun, I know that the gun was ordered as a single trigger. But, must have been sent back to be converted to double triggers. ( there no record of this) Thanks for the input. It helps me learn more about Parkers.
|
||||||
|
|
|
||||||
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
