Looking for Ivory Bead

[J. A. EARLY]

Bob,

I use #661-104-004AH (4mm) sight bead. $13. N.E.C.G. Mamoth Tusk ivory (so according to the catalog no international trade restrictions are violated).

http://www.brownells.com/shotgun-par...?sku=661104004

Pg. 282 of the 2012-2013 catalog.

I was wrong about 2 sizes.

"Undersize 6-48 thread, secure with epoxy adhesive."

I would say that the unaltered hole is probably 3-56. If it has been retapped to 6-48 you are in business. If not you will need to remove material as I described above to make it fit the factory hole.

Jerry

[DDowner]

Thanks all...have two on the way.

[Merv Boyd]

Check with Dale Edmonds. He can fabricate one from mammoth tusk and install it.
Did one for me on a GH. Nice touch and reasonably priced!

[Bill Murphy]

I put one of the CSMC large size ivory beads on my .410. It draws a lot of comments. It looks like it belongs on an eight gauge. It is hard to miss with that gun. I didn't install it, but suspect it is pressed and glued in place.

[J. A. EARLY]

Originally Posted by Bill Murphy

I put one of the CSMC large size ivory beads on my .410. It draws a lot of comments. It looks like it belongs on an eight gauge. It is hard to miss with that gun. I didn't install it, but suspect it is pressed and glued in place.

It was soft enough to self thread into the hole. Turn it out, put the sight in a pin vise, put the pin vise in a drill press, and using a fine emery board(s) purchased at a beauty supply place create the size you want.

Thread it back in place with ever so little super glue so you don't lose it.