Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Welcome & enjoy!
To read the Posts, Messages & Threads in the PGCA Forum, you must be REGISTERED and LOGGED INTO your account! To Register, as a New User please see the Registration Link Above. If you are registered, but not Logged In, please Log in with your account Username and Password found on this page to the top right.
Just went through this (not dents) and posted about it. I finally found the cause to be needing the small long coil spring in the disconnect pin assembly. I replaced it with a new one and everything worked. Just one thing it can be. Take the assembly lose from the trigger plate and if it is easy to reinstall, it is likely too short or broken. I found four broken pieces inside the hole and the active spring less than an inch long.
The Following User Says Thank You to Arthur Shaffer For Your Post:
Threaded Mode