Parts Illustration

[OLD GEEZER]

I was noticing that under Technical Info you can get parts illustration print out of hammerless guns but where do I get one for a lifter hammer gun. Thanks Thomas

[Bindlestiff]

Maybe this will help....................
http://parkerguns.org/pages/faq/FAQs...rWithPhoto.htm

[OLD GEEZER]

Robin: Thanks for the info. I have the gun completely apart and was looking for a complete breakdown of each part and the correct name of them. If possible all the side plate internal parts terminology. Thanks Thomas

[Smoothebore]

Thomas, maybe this will help. There aren't many parts inside a hammer gun lock. The tumbler and sear are shown in this illustration. The little "S" shaped part that connects the tumbler to the main spring is called a stirrup. The part with three screws that holds it all in place is called the saddle. Other than that, there is the main spring, sear spring, and screws.

[OLD GEEZER]

Dave: Thanks Dave that helps a lot.I have some extra parts that I needed identified. Thomas

[OH Osthaus]

Dave

that illustration looks familiar, is it out of one of Shumway's publications?

[Smoothebore]

Originally Posted by Rick Losey

Dave

that illustration looks familiar, is it out of one of Shumway's publications?

I'd like to give credit, but I don't remember what book I copied it from. It was about muzzleloading long guns. When it comes to hammerguns, locks is locks. They are all about the same.

[OH Osthaus]

thanks

if its muzzleloading then is is likely one of Shumway's - i know i have seen it, may be from Recreating the Double Barrel Muzzleloading Shotgun