|
02-20-2016, 10:32 PM | #3 | ||||||
|
1 1/2 frame size was only used on hammerless Parkers.
You can determine the frame size by measuring the exact distance between the firing pins but unless the barrel lug is stamped with the frame size there is no way of knowing the frame size for a orphaned set of barrels. .
__________________
"I'm a Setter man. Not because I think they're better than the other breeds, but because I'm a romantic - stuck on tradition - and to me, a Setter just "belongs" in the grouse picture." George King, "That's Ruff", 2010 - a timeless classic. |
||||||
02-21-2016, 01:17 AM | #4 | ||||||
|
I may be wrong, but I thought early lifters do not always conform to later standard pin spacings. I have a 12ga lifter in the 11000 range that measures smaller than a 1 frame.
|
||||||
02-21-2016, 01:45 AM | #5 | ||||||
|
A measurement could be taken of the inner edge of one chamber to the outer inside edge of the other chamber, or One could measure the distance between the two barrels at the breach and then add the average of the inside diameter of the chambers and come up with a very close guess.
|
||||||
02-21-2016, 06:33 AM | #6 | |||||||
|
Quote:
You're right. I wasn't aware it applied to guns as late as yours. .
__________________
"I'm a Setter man. Not because I think they're better than the other breeds, but because I'm a romantic - stuck on tradition - and to me, a Setter just "belongs" in the grouse picture." George King, "That's Ruff", 2010 - a timeless classic. |
|||||||
02-21-2016, 09:51 AM | #7 | ||||||
|
Maybe it doesn't. I should know better than to post something "remembered" at that hour... Checking back my gun does have the 1 1/16" pin spacing. It was other frame dimensions that I had thought were odd. Sorry for the mistaken post.
|
||||||
The Following User Says Thank You to Eric Estes For Your Post: |
02-27-2016, 06:33 PM | #8 | ||||||
|
Page 527 The Parker Story. All dimensions are there.
|
||||||
03-02-2016, 03:22 PM | #9 | ||||||
|
Kirby, what is your pin spacing?
|
||||||
|
|