|
12-17-2009, 08:05 PM | #3 | ||||||
|
Gregg, It could be as John has mentioned or it could be a worn ejector sear. If it were my gun I would send it to DelGrego as he has the parts to make it right.
__________________
"Much care is bestowed to make it what the Sportsman needs-a good gun"-Charles Parker |
||||||
12-18-2009, 05:08 PM | #4 | ||||||
|
Touching a set of Parker ejectors without being very very very familiar with their operation and potential problems is a recipe for disaster.
DLH
__________________
I was as virtuously given as a gentleman need to be; virtuous enough; swore little; diced not above seven times a week; went to a bawdy-house once in a quarter--of an hour; paid money that I borrowed, three of four times; lived well and in good compass: and now I live out of all order, out of all compass. Falstaff - Henry IV |
||||||
The Following User Says Thank You to Destry L. Hoffard For Your Post: |
12-18-2009, 07:17 PM | #5 | ||||||
|
I removed the forearm wood and no loose parts fell out. If its a worn sear do they recut the notch or does it require a new one?
|
||||||
12-18-2009, 07:37 PM | #6 | ||||||
|
All depends on the amount of wear Gregg...I have seen some that were able to be stoned on the edge and they worked fine.But I have also seen others that were actually chipped and had to be replaced.
__________________
"Much care is bestowed to make it what the Sportsman needs-a good gun"-Charles Parker |
||||||
|
|