Parker Ejectors
 

I have an ejector forearm that keeps kicking the ejector hammer when its removed. It always reset. Now it will not reset at all. What part wears that allows this to happen? I would like to repair this myself but it looks very complicated. Who on this board has experience with these?

Gregg,
That may indicate a broken ejector hammer. I suggest you remove the forearm iron from the wood and check out the inner workings. Be carefull a little piece of metal is likely to fall out. Good luck.

Gregg, It could be as John has mentioned or it could be a worn ejector sear. If it were my gun I would send it to DelGrego as he has the parts to make it right.

Touching a set of Parker ejectors without being very very very familiar with their operation and potential problems is a recipe for disaster.

DLH

I removed the forearm wood and no loose parts fell out. If its a worn sear do they recut the notch or does it require a new one?

All depends on the amount of wear Gregg...I have seen some that were able to be stoned on the edge and they worked fine.But I have also seen others that were actually chipped and had to be replaced.