View Single Post
Unread 02-28-2013, 10:46 PM   #12
Member
edgarspencer
PGCA Member
 
edgarspencer's Avatar

Member Info
 
Join Date: Sep 2011
Posts: 6,604
Thanks: 3,332
Thanked 13,144 Times in 3,482 Posts

Default

Mills, Don't write the barrels off if there is a slight bulged at the forcing cone. I have gun I was lucky with, which had precisely the same bulge, and I was able to 'tap it back down using a piece of think brass stock (.5" x 1") and a small ball peen hammer. I slowly worked the bulge right back to where the barrels were when they left the factory. I did make a mandrel to insert in the bore before I began.
edgarspencer is offline   Reply With Quote