Quote:
Originally Posted by wayne goerres
I was using one of Charlie's favorite loads. 1/8oz no fours 19grs Red Dot in a Remington hull cut down to 2 7/8" with a Rem SP 10 wad and a Win 209 primer. I am not sure about the chokes on the gun. I don't have anything to measure them with properly. Still pretty limited on what you can get your hands on to load with in this area. Would 7625 be a better choice for hunting loads than Red Dot.
|
Yes I think 7625 would be a better choice for a heavier load. 32 grains of 7625 with 1 1/4 ounce is a Sherman Bell load that develops 6700 psi and 1170 fps. I'd feel comfortable upping it to 1 3/8 ounce but that is just me.
There is a lower pressure published load for Longshot powder using 1 3/8 ounce of Nice Shot in the Federal Hull. 8800 psi with a velocity of 1335 fps. Remember Nice Shot is loaded to lead recipes adding and additional 1500 psi. In this case you are going from Nice Shot to lead so that should be 1 3/8 of lead moving at 1335 with a pressure of 7300 psi. If it patterns well that would be a good turkey load in a composite barreled short ten.
If the Red Dot is not giving you the pattern you are looking for try 22gr of Green Dot with 1 1/8 ounce. I have used that a lot on clay pigeons. When I really want to reach out and touch crows I used 27gr of Green Dot with 1 1/4 ounce. Alliant has published loads for GD using 29 grains with 1 1/4 ounce in a 3.5" hull, pressure is 8800 psi and velocity 1265. I have shot a lot of them through a twist barrel NH without issue.
Closer is almost always better, but short tens that can pattern in the high 80 and low 90 percent at 40 yards with 1 1/4 ounce loads are very effective beyond that range. However Turkey's are not ducks.