Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Welcome & enjoy!
To read the Posts, Messages & Threads in the PGCA Forum, you must be REGISTERED and LOGGED INTO your account! To Register, as a New User please see the Registration Link Above. If you are registered, but not Logged In, please Log in with your account Username and Password found on this page to the top right.
Thanks Scott. That's basically what I was planning to do. My only difficulty is although I have a half dozen Parkers, this 10ga that I'm working on is the only straight stock I have right now. This leaves me without a pattern to work with, but I believe that using the inletting on the gun and screw hole positions along with some good close-up photos from mother straight stock Parkers will guide me to a workable solution.
The Following User Says Thank You to Elvin Ehrhardt For Your Post:
Threaded Mode