Finally set up the drill press for roll crimping

[Stan Hillis]

Keith and Milton, my bad for calling it by the wrong name. The Sizemaster is indeed a press that uses the collet type resizing, but the tool I have is called a SuperSizer. My apologies for using the wrong name and causing confusion. I just realized my error.

I think mine is still set up on the drill press table, from my last loading session with 3" .410 nickel plated shot loads. I'll take a peek in a few minutes and, if it is, I'll snap a pic and put it on here tonight. Again, sorry for the confusion I caused.