Chuck, Kurt & Bill,
Thanks so much for your replies and information.
The receiver is factory solid tight and I see what your concerns are about the 1/4" gap on the top view photo, however, it is as tight as can be. I didn't take a bottom picture but the receiver is solid against the stock underneath.
I found the serial number on the barrel as you said Chuck, so it is the original barrel. It has TWIST at the end of the logo in between the barrels after the Parker Bros. Meridian etc.
What is the average value of this gun? I would rate it below average or average because of the rust and pitting but it shoots and it is just an old original gun.
Thanks, Jim
|
Threaded Mode