Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Welcome & enjoy!
To read the Posts, Messages & Threads in the PGCA Forum, you must be REGISTERED and LOGGED INTO your account! To Register, as a New User please see the Registration Link Above. If you are registered, but not Logged In, please Log in with your account Username and Password found on this page to the top right.
Purchased a set of feeler gauges from an auto parts store. Roughed up the mating surfaces. Used Devcon as the adhesive. Held it in all place with a 3/8" drive socket extension wrapped in masking tape, wood blocks and a c-clamp. A small amount of sanding with a dowel wrapped in emory cloth was all that was needed to finish the fit. Tight on face, no shake, all is well.
Last edited by Bill Graham; 07-28-2016 at 02:24 PM..
Reason: Fixed a typo
The Following 2 Users Say Thank You to Bill Graham For Your Post:
Threaded Mode