|
09-06-2011, 11:04 AM | #3 | |||||||
|
Quote:
Correction: Circle Fly. Somebody suggested warming them a bit before loading. The lube was quite firm and waxy. Last edited by Jeff Mayhew; 09-06-2011 at 03:06 PM.. |
|||||||
09-06-2011, 08:49 PM | #4 | ||||||
|
i too have run into the problem you have...making a airway is good medicene... charlie
|
||||||
The Following User Says Thank You to charlie cleveland For Your Post: |
09-14-2011, 06:19 PM | #5 | ||||||
|
It's something you'll have to put up with. When loading muzzleloading shotguns the wads must be reseated because of compressing the air. I used to push the wad down fast and let go of the ram rod and it would jump back up almost out of the barrel. It would take another push or two to make sure the wad was seated. Then kind of throw the rod hard back down the last couple of inches and make it bounce. I never noticed it with brass shells but my wads were probably not as tight as your wads. Your first over powder wad should be the one that is the tightest. It's a hard card about .140- then your buffer wad [ or cushion wads as I call them ] . You are useing an overshot wad aren't you ? Any ways, just reseat your wads a couple of times before you put in the shot - you don't have to cut them. Good luck - Paul
|
||||||
The Following User Says Thank You to Paul Harm For Your Post: |
09-14-2011, 10:52 PM | #6 | ||||||
|
Thanks Paul. I'm using an overshot "card" of thin cardboard (see "G" in the picture, below). Are you suggesting I need something in between the shot and this card? None of the instructions I have found suggest this, although I suppose a "cushion" to take up any slack caused by settling shot might make sense.
I did fire the shells, and they worked perfectly. What a blast! |
||||||
The Following User Says Thank You to Jeff Mayhew For Your Post: |
10-26-2011, 10:11 AM | #7 | ||||||
|
Sorry I didn't get back sooner - PC broke. Nice picture - no, you're doing it right. And yes, you want the wads down tight on the powder - no air gap. I get all my wads from Circlefly. I wouldn't cut or put any kind of hole in the wads to let pressure leak through, you'd be defeating the purpose of tight wads. You'll just have to reseat the wads. Years back my friend was sighting in a 72 cal ML rifle. He had just seated the ball and had to leave for a minute or two. He left the ram rod down the barrel so when he came back he knew where he was in reloading. When he returned the ram rod was about 8" back up the barrel. He reseated and shot the gun. Reloaded again , sat down and shortly thereafter watched the ram rod slowly come back up the barrel. This was back in the 70's and some fellows had blew up ML rifles that were written up in national magagines. Guess that explained why. My friend was reloading with the hammer on the nipple - the compressed air had no where to go. Maybe this explained why some guns blew up. Not saying this would happen with your shotgun shells , but you shouldn't leave any air gap between the powder and wads. Paul
|
||||||
The Following User Says Thank You to Paul Harm For Your Post: |
|
|