Looking for an approximate value

[Pete Swartz]

Any ideas on value? Looks like 1901model - 58,000 made - TY!!

28 inch barrel.

[Dean Romig]

It looks pretty decent but without barrel wall thicknesses, bore and choke measurements, barrel length and serial number to find original configuration and barrel length it would be hard to put a high end figure on it.





.

[Pete Swartz]

TY - will look for that data.

[winplumber]

It is a Grade 2 or a GH and your serial number 107882 is not in the serialization book Looks to be a honest gun

[Pete Swartz]

Yes - s/n is 107882. It is stamped many times on a the gun. How/where can I get the barrel wall thickness?

[Pete Swartz]

Yes - s/n is 107882. It is stamped many times on a the gun. How/where can I get the barrel wall thickness and the other data mentioned?

[winplumber]

The barrel wall thickness has to be measured by a person with a gauge made to do so . Could you post a picture of the top end of rib in front of the bead , will narrow one guess down of the correct barrel length . What is the length of the barrels ?

[winplumber]

You could order a research letter on your gun its cheaper if you become a PGCA member the letter will give you info on grade barrel length and who may have ordered it . Go to the Home page and click on research letters for details. The letter will not give you the barrel wall thickness. That has to be checked as stated before

[winplumber]

Rib matting is correct looks to be original where you located maybe some one closeto you could measure the Bwt and help you out one the value ,

[Pete Swartz]

Originally Posted by Steve Huffman

The barrel wall thickness has to be measured by a person with a gauge made to do so . Could you post a picture of the top end of rib in front of the bead , will narrow one guess down of the correct barrel length . What is the length of the barrels ?

28 inch barrel - added pics requested.