|
11-29-2023, 06:10 PM | #3 | ||||||
|
And epoxy will do really. Color it black.
Acriglass is a thin 24 hr epoxy. Which can be tricky to work with if you are needing to repair a large missing piece vs just glue two pieces together. A faster acting gel epoxy may serve you better depending on what is needing to be done.
__________________
B. Dudley |
||||||
The Following 4 Users Say Thank You to Brian Dudley For Your Post: |
11-30-2023, 12:16 AM | #4 | ||||||
|
I have always used J&B for buttplates. It is pretty thick and a grey color that can be blended with epoxy pigment powder to match the color. It seems to match the texture of the old plates pretty well. If you want it really thick and nonslumping, blend in some microspheres that the boat builders use to make nonrunning epoxy glues.
|
||||||
The Following 3 Users Say Thank You to Arthur Shaffer For Your Post: |
11-30-2023, 10:55 AM | #5 | ||||||
|
Cold Spring (Frank Srebro) posted a thread with photos on repairing a butt plate with a broken missing piece. If you search on here you should find it.
|
||||||
The Following 3 Users Say Thank You to Mike Koneski For Your Post: |
11-30-2023, 11:24 AM | #6 | ||||||
|
I have used Acraglas Gel, dyed black, to fill a chunk missing from a Lefever butt plate. After shaping and finishing, the repair is undetectable. The colors blended perfectly. The gel gives you a bit more time to work with it. Good Luck!
__________________
GMC(SW)-USN, Retired 'Earnest Will' 'Desert Shield' 'Desert Storm' 'Southern Watch' |
||||||
The Following 3 Users Say Thank You to Mark Landskov For Your Post: |
11-30-2023, 12:46 PM | #7 | ||||||
|
I used black epoxy to repair a chunk missing from a recoil pad base plate. Ordered it already black from Amazon I think.
__________________
It ain't what you don't know that gets you into trouble. It's what you know for sure that just ain't so. - Mark Twain. |
||||||
The Following User Says Thank You to Phil Yearout For Your Post: |
11-30-2023, 08:15 PM | #8 | ||||||
|
Actually Mike it was in the Spring/Summer Fox Newsletter. I use Acraglas liquid, dyed black, and with pieces of small brads (nails) to tie the repair into the broken section of the buttplate.
|
||||||
The Following User Says Thank You to Frank Srebro For Your Post: |
12-01-2023, 11:42 AM | #9 | ||||||
|
One other thing I didn't mention was that I have done several chipped off heel and toe sections. I carefully waxed the wood right up to the butt plate, then wrapped several layers of wide masking tape around the bottom or top of the stock as needed. Keep it perfectly level on the stock and use enough layers to form a relatively stiff form. Then fill the form to the proper level, using a tooth pick or similar to completely fill it. When dry, romove the tape and put masking tape around the stock wood for protection. Then sand the toe or heel to shape and sand/polish the new section (or the whole thing if needed) with progressively finer paper, down to 1200 or so. A final polish and a coat of TruOil if desired, and you should have a restored original.
|
||||||
The Following User Says Thank You to Arthur Shaffer For Your Post: |
|
|