|
 |
 |
||||||||||||||||||||||||||||||||||||||
| |||||||||||||||||||||||||||||||||||||||
 |
 |
04-30-2010, 11:15 AM
|
#3 | ||||||
|
William: I would also suggest ordering a Parker letter. This will tell you a whole lot more such as the original specifications and possibly the buyer.
Best Regards, George |
||||||
|
|
||||||
 |
 |
 |
| The Following User Says Thank You to George Lander For Your Post: |
|
|
|
05-02-2010, 06:30 AM
|
#4 | ||||||
|
If it's a lifter I'd imagine there isn't any rib matting. Am I wrong?
Destry
__________________
I was as virtuously given as a gentleman need to be; virtuous enough; swore little; diced not above seven times a week; went to a bawdy-house once in a quarter--of an hour; paid money that I borrowed, three of four times; lived well and in good compass: and now I live out of all order, out of all compass. Falstaff - Henry IV |
||||||
|
|
|
||||||
|
|
|
|
|
|
05-02-2010, 08:36 AM
|
#5 | ||||||
|
Destry is correct. If we could get a better look at the muzzel and how the barrels touch some might be able to tell if the barrels have been cut or not.
Harry |
||||||
|
|
|
||||||
|
|
|
|
|
|
05-04-2010, 08:10 PM
|
#6 | ||||||
|
Those lifters were often "meaty" In finishing the barrels not much metal was removed. If you weigh the barrels you might find that only 4 oz. was removed from the weight stamped on the flats instead of 8 oz. as is usual for later guns. I think the formula is that usually the barrels weigh 88% of stamped weight but lifters were often in the 92% area.
David |
||||||
|
|
|
||||||
|
|
|
|
Barrel thickness | |
|
05-04-2010, 09:18 PM
|
#7 | ||||||
|
Barrel thickness
Choke began to be fairly regular after s/n 10000 or so. Early Parker full choke was .032 that is 1/32 inch. If the barrel was .030 thick behind the choke it would be .046 at the muzzle- more than a millimeter.
Best, Austin |
||||||
|
|
|
||||||
|
|
|
 |
|
|
Linear Mode
