Adding recoil pads

[Kurt Sauers]

Most of all the repros i have seen are too short for me. What's it going to do to the value by adding a recoil pad around 3/8 or so?

[Bob Jurewicz]

I would guess cutting stock for a pad will reduce value by at least 20%. I don't think a pad could be installed without cutting a flat installation surface.
Bob Jurewicz

[Dean Romig]

By all means use a slip-on pad like a Galco or some other quality one. I would highly recommend NOT cutting the stock.






.

[Gary Laudermilch]

I would look a bit harder for a long LOP gun. They come up somewhat frequently. How much of an increase do you need? Sounds like not too much if you only need a 3/8 pad.

[Opening Day]

As Dean says put on a quality slip on you can also add some extra foam to the pad if you need a little extra length. Cutting off the SSBP will seriously drop the value of the gun plus even at a reduced price make it very hard to sell so if you still want to do this, plan on keeping the gun a long time.

[Wilmurt]

Slip on by all means

[B. Dudley]

Originally Posted by Kurt Sauers

Most of all the repros i have seen are too short for me. What's it going to do to the value by adding a recoil pad around 3/8 or so?

Most complain about them being too long.

[MD*GSP]

Originally Posted by Brian Dudley

Most complain about them being too long.

That's a surprise and seems to be contrary to what the interweb would have one believe. I'm curious..at a practical level, what would you say is the prevailing l.o.p most often requested/required?

(Anywhere from 14 thru 14-1/2 seems to work well for me at 5'9 & an average build)

[Bill Murphy]

I fairly successfully shoot side by sides from 13 1/2" to 15 3/4". My pair of William Evans sporting clays guns are 15 3/4" to the front triggers and I shoot them as well as any of my other guns.

[C.O.B.]

I like a 15 inch LOP for a two triggered gun. I can get by with a slightly shorter one with a SST gun.

If your Repo is to short by all means use a slip on pad.