Welcome to the new PGCA Forum! As well, since it
is new - please read the following:
This is a new forum - so you must REGISTER to this Forum before posting;
If you are not a PGCA Member, we do not allow posts selling, offering or brokering firearms and/or parts; and You MUST REGISTER your REAL FIRST and LAST NAME as your login name.
To register: Click here..................
If you are registered to the forum and keep getting logged
out: Please
Click Here...
Started on the new block I bought. Made two 10mm blocks (9mm will work in it was well) and two 22 hornet blocks. Still have to sand and varnish the last two I cut out of the block. Sanding out the the old previous cut scars on the blocks are a pain. Used a 1/2” bit for 10mm and 3/8” for 22 Hornet. The little piece of the block I cut from the neck will hold 15 Hornet shells. Figured it was better then tossing it.
Threaded Mode