572/MEC bushings

[john pulis]

Has anyone worked out grains per bushing for Winchester 572 powder? I searched the MEC website but could not locate an updated bushing powder chart. 572 was not cited.

Kind regards,
John

[edgarspencer]

John, I found 572 meters a little inconsistently. 572 is more consistent for me on the 600Jr, than it is on the 9000.The charts are a good starting point, but what one guy gets on his press may not be the same as another guy, especially if presses are different. All that, and I find it dirty too. Looks like it will come down to what's available.

[J.B. Books]

Hodgdon say it meters the same as Longshot. As always confirm with your scale. I literally just got some to try but looking at how little volume this powder takes up it will require a tall wad for 20 ga 7/8 ounce loadings (you might have to substitute the CB 3/4 wad where it lists the CB 7/8 wad. If you are looking for low pressure in a 20ga with 7/8 oz the Federal hull is the best choice listed especially if you keep velocity at 1150.

https://hodgdonpowderco.com/wp-conte...art-2017-1.pdf

[edgarspencer]

Pete, while you can use the same bushing, grain for grain, the 572 has greater deviation than Longshot. The 572 bottle says "Clean Burning", but that was not my experience.
I tried 100 rounds of 28ga using 572, and I too found the volume an issue. Fortunately I have a good variety of wads. I think I ended up using the BP2895, but that wad is too expensive. My normal, RO-28 Fiocchi wad and 20/28 gives me my best 3/4oz crimp (I'm loading only 2 1/2")
I went to Cabelas for shot today, and they did have plenty of Longshot and 572 on the shelf.

[john pulis]

Thanks all. Advice needed.

[J.B. Books]

Originally Posted by edgarspencer

Pete, while you can use the same bushing, grain for grain, the 572 has greater deviation than Longshot. The 572 bottle says "Clean Burning", but that was not my experience.
I tried 100 rounds of 28ga using 572, and I too found the volume an issue. Fortunately I have a good variety of wads. I think I ended up using the BP2895, but that wad is too expensive. My normal, RO-28 Fiocchi wad and 20/28 gives me my best 3/4oz crimp (I'm loading only 2 1/2")
I went to Cabelas for shot today, and they did have plenty of Longshot and 572 on the shelf.

With the powder shortage and Alliant suspending their production it seems we have to shoot what we can find. I will always prefer Alliant powders and have a good supply but it won't last forever and as the saying goes beggars can't be choosers. Hoping the 572 will make 20ga loads that go boom.

[john pulis]

Pete,

That was my thinking about powder shortage. CAC had 17 572 4 pounders so I figured I should purchase some before they too disappear. I also purchased 8 lbs of Bullseye, yes, not the best but the old Hercules manual had several 7/8 loads. CAC had 49 in stock. Beggars can’t by chooses.

Thanks all,
John

[6pt-Sika]

I had I think 24 pounds of 572 and sold about half of it . Don’t remmember what application I planned using it for .

[Mike of the Mountain]

Originally Posted by CraigThompson

I had I think 24 pounds of 572 and sold about half of it . Don’t remmember what application I planned using it for .

Blasting woodchucks out of their dens?

[6pt-Sika]

Originally Posted by Mike Koneski

Blasting woodchucks out of their dens?

Nah I’ve not bothered the wee grun sow in quite awhile .