|
05-14-2019, 07:00 AM | #3 | ||||||
|
Brian Board has the solution----------"Timber Lux"
|
||||||
The Following 2 Users Say Thank You to Jean Swanson For Your Post: |
05-14-2019, 07:52 AM | #4 | ||||||
|
Just checked the box and it is a grade of pumice called rotten stone, the finest grit, made by a co. called Rainbow. It is made for that purpose.
|
||||||
The Following User Says Thank You to Daniel Carter For Your Post: |
05-14-2019, 08:13 AM | #5 | ||||||
|
I agree, after trying all sorts of commercially available offerings, and a few private recipes of professional gunmakers.
For me, it really is the easiest, and most forgiving. I do pay attention to what Brian has told me about keeping the humidity about 35% and temp 70-75 seem to be ideal conditions. Too shiny for taste, you can knock it back with fine steel wool. I recently did my pheasant gun, which had patches of original finish, but I got it good and wet last fall. 2 lite applications of Timberlux and it looks vintage correct, and has better protection. www.timberluxe.com |
||||||
The Following User Says Thank You to Brett Hoop For Your Post: |
05-14-2019, 08:21 AM | #6 | ||||||
|
Thanks guys for the replys, I already have finished the stock with about 10 coats of oil, sanded each coat and reapplied, the finish looks really good, just too shiny for my liking, will timberluxe knock it back? I think I might try the pumice, but a little nervous as this finish took a lot of hours. I just need to get the glare knocked back without turning the finish white. maybe a 1500 grit sanding then the timberluxe?
|
||||||
05-14-2019, 08:56 AM | #7 | ||||||
|
I have used 1500 wet sanding and found it to dull and patchy. Try the rottenstone on an old stock first to get a '' feel'' for it and I think it will give you the result you want. I bought it years ago at a paint store, if you have a hard time finding it I will send you some.
|
||||||
The Following User Says Thank You to Daniel Carter For Your Post: |
05-14-2019, 04:19 PM | #8 | |||||||
|
Quote:
Also, Birchwood Casey's stock polish can be used to take off some of the sheen. Just go very lightly. Timberlux is a finish and is not used to knock back the sheen on a stock. |
|||||||
05-14-2019, 06:03 PM | #9 | |||||||
|
Quote:
Thanks guys for all your help I really do appreciate it! |
|||||||
The Following User Says Thank You to Rick Riddell For Your Post: |
05-16-2019, 05:48 AM | #10 | ||||||
|
Rick, before you try to dull down your finish, make sure it is fully cured. Especially if it's an oil finish. What i like to do is take an old mustard bottle and mix some mineral oil with rottenstone. The ratio is not important, just put in enough rottenstone to thicken it up so it's not so runny. Shake it up and squirt some on a soft cotton cloth and rub away with circular,even motion. The rottenstone along with the mineral oil is so fine that it's cutting action is very slow and subtle. You will have to wipe the stock with mineral spirits to check your progress due to the mineral oil making the finish still shine. I have found this to be effective an effective way without removing to much at a time.
|
||||||
The Following 2 Users Say Thank You to Andrew Clark For Your Post: |
|
|