|
 |
 |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
 |
 |
12-04-2015, 03:04 PM
|
#3 | ||||||
|
I agree Brian. I have two or three small bore Grade 3 Parkers with dogs done by the same hand... My guess is Harry Gough. I'll have to check The Parker Story for the facts on Gough, but I believe if he was an independent contractor he wasn't beholden to Parker Bros. to engrave exclusively for them and could take in work from other manufacturers.
We see evidence of that being done by other engravers. Some changed employers while others simply did contract work for different manufacturers. Both of these guns were manufactured in 1908. .
__________________
"I'm a Setter man. Not because I think they're better than the other breeds, but because I'm a romantic - stuck on tradition - and to me, a Setter just "belongs" in the grouse picture." George King, "That's Ruff", 2010 - a timeless classic. |
||||||
|
|
||||||
 |
 |
 |
|
|
|
12-04-2015, 07:44 PM
|
#4 | ||||||
|
Here's an earlier thread regarding a Stevens 350 with PB like features.
http://parkerguns.org/forums/showthread.php?t=12807 Erick |
||||||
|
|
|
||||||
|
|
|
|
|
|
12-05-2015, 07:25 AM
|
#5 | ||||||
|
The trigger plate photo from that other thread looks to be the same gun as the subject gun in this thread. The one started in that other thread is different.
__________________
B. Dudley |
||||||
|
|
|
||||||
|
|
|
|
|
|
12-05-2015, 08:55 PM
|
#6 | ||||||
|
Brian,
In the earlier thread the trigger plate is on same gun as first photos in that thread. Definitely a different gun in poor condition. Two different 350's showing the same engraving pattern. Erick |
||||||
|
|
|
||||||
|
|
|
|
|
|
12-05-2015, 09:07 PM
|
#7 | ||||||
|
In J. Stevens Arms & Tool Co. Catalog No. 51 where the No. 350 was introduced it wasn't an engraved gun --
 The same gun with Twist tubes screwed into the mono-bloc was the No. 360 and with Damascus tubes the No. 370 --  By Catalog No. 52 they added a No. 380 with Krupp tubes screwed into the mono-bloc. I suspect this was a special No. 350 for a Sportsmen's Show or Exhibition. Very soon J. Stevens Arms & Tool Co. dropped the mono-bloc barrels and went to their demi-bloc (chopper lump) barrels --  They issued a special Demi-Bloc shotguns Catalog and by General Catalog No. 52 (Revised Edition), and the guns became the No. 355 with Stevens Compressed Forged High Pressure Steel barrels --  the No. 365 with Krupp Fluid Steel barrels --  the No. 375 with Krupp barrels and some engraving --  and the No. 385 with Krupp barrels and more engraving --  By the last J. Stevens Arms & Tool Co. catalog, No. 54, these engraved and rotary bolted doubles had been dropped from the offerings. |
||||||
|
|
|
||||||
|
|
|
| The Following User Says Thank You to Dave Noreen For Your Post: |
 |
|
|
Linear Mode
