Newest indulgence - Page 3

Keavin Nelson · 09-03-2017, 11:35 AM

If it hadn't been cut down to only 12", I would try the same. Have several guns repaired that way. Since I already have the wood, a new stock is in order.l

Keavin Nelson · 09-16-2017, 06:05 PM

So we now have the letter, and the plot thickens!

Letter says pistol grip stock, with no safety, rubber pad, light trigger pulls. This gun is straight grip, WITH a safety. SN is on both the stock as well as the back of the trigger guard.

More pictures to come.
It did go back to Parker, but only for a bite block.

Keavin Nelson · 09-16-2017, 06:26 PM

A few more pictures, the tang safety, and the new wood, tough day in the shop!

edgarspencer · 09-16-2017, 09:54 PM

That's a nice piece of lumber. Don't forget to put the sears back in.

Keavin Nelson · 09-17-2017, 11:23 AM

Quote:

Originally Posted by edgarspencer

That's a nice piece of lumber. Don't forget to put the sears back in.

Yes and everything else. Discovered the triggers were reversed yesterday!

Much left to do, cut to length after I decide if I will put a pad on as it was originally. And then to checker it.

The wood actually came with the gun, and it was well inletted. Very petite butt, just barely larger than an O size butt plate. Not would you would normally see on a 2 frame gun.