|
12-04-2010, 10:16 AM | #23 | ||||||
|
If you can find the forend iron would be a big help. I think GB is a great idea because somebody will want it for parts.
|
||||||
12-04-2010, 11:00 AM | #24 | |||||||
|
Quote:
The ironic part is that he thought the gun was worthless and the only reason that he did no put it into the trash years ago, was that he figured he would get into trouble for tossing a shotgun into the garbage can for pick up... luckily I came along and saved whats left of it... John |
|||||||
12-04-2010, 11:03 AM | #25 | |||||||
|
Quote:
I would love to see this old boy restored. and yes it would be a challenge, I would take it on myself if it were an old Mauser or Garand. However I have restored rifles in similar if not worse condition, However I have never messed with a damascus barrel...... John |
|||||||
12-04-2010, 11:43 PM | #26 | ||||||
|
johnmac: Your D Grade hammergun with the scalloped breech balls is a rareity in 10 gauge on a #4 frame & 32 inch barrels. If the barrels are not in too bad a shape a good Parker gunsmith could restore it for you and then you would have a treasure. Think hard about it before parting it out. Where are you located? We can, most probably reccomend someone who would give you a fair estimate for restoration.
Best Regards, George |
||||||
12-05-2010, 08:28 AM | #27 | ||||||
|
johnmac,
If it were mine I would NOT part it out! George is correct that a #4 frame D Grade is rare. The condition is however poor with surface pitting on most if not all of the metal. A complete restoration will be expensive. For this rare Parker please consider the following options: 1. Restore is to like new condition and enjoy a rare Parker 2. Restore it to shootable condition and enjoy shooting a rough but rare Parker! 3. Sell it to somene who will restore it and enjoy it. Respectfully, Mark |
||||||
12-05-2010, 10:23 AM | #28 | ||||||
|
George and BFT I appreciate the straight forwardness and help with my decision. My only questions now are what MIGHT a full restoration by a qualified Parker man?
and two, how rare and what could it potentially be worth to me..... Man decisions decisions decisions! Anyway thanks to the both of you John m. |
||||||
12-05-2010, 11:14 AM | #29 | ||||||
|
I would "guess" a full restoration would be $6000 plus. I see on Doug Turnbull's web site he estimates a full restoration of a VH at $3600 plus, so I would assume you couldn't get the additional engraving and a new stock for any less than $6000. And that may be very conservative.
If you are serious abut restoring it, I might suggest you contact him at www.turnbullmfg.com and send him these pictures and get his estimate. That would be a good start and you could get other estimates if you think it worth while. As to what it would be worth after the restoration, I suspect less than the cost to restore it. How much less I don't know. Other here may have better advise or opinions on its value. |
||||||
12-05-2010, 01:19 PM | #30 | ||||||
|
Yeah.... That's what I was afraid of.... That's way too far out of my budget. Seems my choices are limited to passing it on. I just hope whoever ends up with it restores it rather than parting it out. I would love to see it restored....
Thanks again guys John |
||||||
|
|