|
Well this is fun..... |
03-31-2018, 01:17 PM | #23 | ||||||
|
Well this is fun.....
I actually have an idea what those gizmos are...and going along with that when you start measuring for accuracy take into account just how long can I hold my hand perfectly still to get a "solid" reading? and what is the temperature of the room I am measuring in, how do I take into account thermal expansion, does it matter ? well yes and no, and yes and know.. depends on the kind of tool you use to split the hair and the type of surface finish I have achieved in my final process. Lots of variables to consider. ..as has been stated by others, that thousandth or two won't matter much if I point and shoot straight. I am always humbled by the fact that the Parker gun is such a Marvel of metal and wood, balance and artistry and has been for well over 125 years....I am still studying but I should get back to my chores..Happy Easter to All...Thanks & Best,Paul
|
||||||
04-02-2018, 11:18 AM | #24 | ||||||
|
Bill, just so this thread doesn't become inundated with technical jargon..I'll pm my email address. I'd be happy to help you sort through and identify the various items if you'd like.
|
||||||
04-02-2018, 04:24 PM | #25 | ||||||
|
I just measured a 20GA two barrel set that I just bought and it measures as follows:
26 inch barrels = RT .618 bore .010 Constriction, LT .617 bore .016 constriction 28 inch barrels = Rt .617 bore .016 Constriction, Lt .617 bore .035 constriction I've always been impressed by how consistent the bores measure on these guns with very little variation. 26 inch barrels have 2 3/4 inch chambers 28 inch barrels have 3 inch chambers and both marked properly |
||||||
The Following User Says Thank You to Gerry Addison For Your Post: |
04-02-2018, 05:40 PM | #26 | ||||||
|
Wow, .035 on a 20?! Extra extra full.
|
||||||
The Following User Says Thank You to Kirk Potter For Your Post: |
05-26-2018, 02:21 AM | #27 | ||||||
|
My new-to-me 12g DHE measured with my Skeet's bore gauge:
28" M/F: Bores .735", R=.011" L=.037". |
||||||
05-26-2018, 08:50 AM | #28 | ||||||
|
Welcome to the forum Steven! Congratulations on your 1st post and your new-to-you 12-ga. How about doing a little show & tell in the "Let's See Some Wood" thread", please?
__________________
Wild Skies Since 1951 |
||||||
05-27-2018, 12:02 PM | #29 | ||||||
|
In the first post, Bob had the 12ga ic/mod at 6 and 10. Is that typical for all the 12ga repro's to be that open?
|
||||||
05-27-2018, 12:10 PM | #30 | ||||||
|
All of the 26" Ic/M barrels I measured were in that range.
Bob Jurewicz |
||||||
|
|