Parker Stock Removal - Page 2

B. Dudley · 10-13-2011, 09:56 AM

I figured the pushrod had to be keyed to the ferrule. But I would have never thought that the ferrule was threaded in.

Kensal Rise · 10-13-2011, 06:53 PM

Dudley:
Yes. This is why it has notches -- really the very outer ends of a screw slot. There is only about .25 inches of fine thread. When the ferrule stops unscrewing upward, it's time to tap it out from the bottom.

Best, Kensal

B. Dudley · 10-14-2011, 09:49 PM

Got it out no problem. I found that a bit in my Magna-tip thin bit set from Brownells fit perfectly.
Bit #270-2
Width: .270 (6.8mm)
.025 thick.