What do I need to finish gun?

[edgarspencer]

Originally Posted by Randy G Roberts

Dean I would think the bolster measurements would rule out the possibility of this being a 28 gauge. Would you agree with that?

Originally Posted by Dean Romig

No Randy that wouldn't rule out a 28 gauge. I had one that accepted a set of 20 ga. barrels perfectly.

One of my 0 frame 28ga. guns is amongst the earliest 28s, (one of a identical pair ordered in 1900 by Folsom, the first documented 24" 28ga. guns) and the bolster measurement is .078" smaller than my other, and that one, including all my other 0 frame guns measure withing a few thous of 2 1/16"

[Aaron Beck]

Based on what the cut 16 ga damascus barrels on gunbroker went for the other day, it seems like you could replace the missing half. Gunsmith to fit likely required.

[edgarspencer]

Originally Posted by Aaron Beck

Based on what the cut 16 ga damascus barrels on gunbroker went for the other day, it seems like you could replace the missing half. Gunsmith to fit likely required.

That barrel was not cut. It was 26" and is in the 'book' at 26", from a CHE.

[Dean Romig]

There is always the same ad in DGJ from someone who buys SXS barrels of all makes. I can only imagine this person also sells barrels. The only contact is through DGJ so I would give Daniel Cote a call and ask if this person has barrels to sell, including barrels that might fit your Parker.





.

[edgarspencer]

Originally Posted by Dean Romig

There is always the same ad in DGJ from someone who buys SXS barrels of all makes. I can only imagine this person also sells barrels. The only contact is through DGJ so I would give Daniel Cote a call and ask if this person has barrels to sell, including barrels that might fit your Parker.

That is Daniel who is buying barrels.

[Mills]

Originally Posted by edgarspencer

That is Daniel who is buying barrels.

That means one call instead of two. Good luck!

[Dean Romig]

Okay, that’s even better.





.