|
06-17-2024, 04:07 PM | #13 | ||||||
|
I worked the top lever and open/closed the action a few times. Didn’t dry fire w the snap caps for fear it would lock up again. Everything worked, but the top lever motion feels gummy and the action is really tight.
|
||||||
Repro |
06-17-2024, 05:13 PM | #14 | ||||||
|
Repro
Had exact problem with a 20 Repro, gun got hot and would not open. Needs to be taken down and get the dried up grease/ oil cleaned out and lightly re oiled at right spots. Would not be shocked to see it double on occasion, have had to do this to 3 different un-shot guns.
Find someone familiar with doubles and single triggers, not average gunsmith. Good luck. |
||||||
Needed repair VHE-12 to remove barrels |
06-18-2024, 07:29 AM | #15 | ||||||
|
Needed repair VHE-12 to remove barrels
I just had this issue. The reason the gun would not release the barrel hook to remove the barrels. I think from sitting i a heated safe for extended periods the lube or oils dried up and froze two moving parts. The for end indicator shaft that protrudes out of the receiver was stuck in and the slider mounted to the belly plate was also not moving. SEE PICS This was an easy fix but correct screw drivers are a must and may need hand fitted to the screws slots so not to booger them up! SXS Ohio
|
||||||
The Following 3 Users Say Thank You to Kenny Graft For Your Post: |
|
|