|
04-12-2022, 01:45 PM | #13 | ||||||
|
Mostly due to guys reloading shells with equal weight of nitro for black. That is a recipe for disaster even with modern guns. Not every shooter was reloading with smokeless when it first appeared so it did take a few years for the reloaders to catch up with the modern propellants.
|
||||||
The Following 4 Users Say Thank You to Mike Koneski For Your Post: |
04-12-2022, 01:53 PM | #14 | ||||||
|
I think Mike is right, although I also think the gun manufacturers loved an excuse for everyone to buy a new gun
__________________
Whoever said you can't buy happiness forgot little puppies. Gene Hill |
||||||
The Following 4 Users Say Thank You to Mills Morrison For Your Post: |
04-12-2022, 02:05 PM | #15 | ||||||
|
|
||||||
The Following 8 Users Say Thank You to Dylan Rhodes For Your Post: |
04-12-2022, 02:10 PM | #16 | ||||||
|
I am the master of excuses to buy new guns
__________________
Whoever said you can't buy happiness forgot little puppies. Gene Hill |
||||||
The Following 7 Users Say Thank You to Mills Morrison For Your Post: |
04-12-2022, 02:12 PM | #17 | |||||||
|
Quote:
True, but I think fluid steel barrels would have suffered the same catastrophic failures when fired with such loads as did some Damascus barreled guns. .
__________________
"I'm a Setter man. Not because I think they're better than the other breeds, but because I'm a romantic - stuck on tradition - and to me, a Setter just "belongs" in the grouse picture." George King, "That's Ruff", 2010 - a timeless classic. |
|||||||
The Following 5 Users Say Thank You to Dean Romig For Your Post: |
04-12-2022, 02:17 PM | #18 | ||||||
|
I remember a previous discussion on this forum in which someone posted ads and warnings that appeared in the press at the time warning about not using your black powder measure to load the new smokeless powder by volume. It was found to be the reason that barrels were failing because of the gross overload. Once people became aware of that the problem went away until 1937 or so when the warnings appeared.
|
||||||
The Following User Says Thank You to Daniel Carter For Your Post: |
04-15-2022, 01:17 PM | #19 | ||||||
|
A pretty exhaustive study of damascus barrels and pressures was featured in the Double Gun Journal some years back.
Many of the problems in the 20s and 30s were traced back to cheap twist or damascus barrels made in Belgium in guns that found their way into the USA. The quality of Parker Bros. damascus barrels and their inherent strength was demonstrated in this article. There are damascus barrels and then there are other damascus barrels. Caveat emptor. |
||||||
The Following 5 Users Say Thank You to henderson Marriott For Your Post: |
07-13-2022, 10:12 AM | #20 | ||||||
|
Just reviewed the excellent series of special subjects toward the end of the
LC Smith Collectors site forums. Comprehensive listing of powders, black vs nitro; use of Damascus guns and nitro shell loading of smokeless or semi-smokeless by weight rather than volume; AND the size of some 3 1/4 inch 12 ga shells used by competitors in live pigeon shoots like Gilbert. The LC Smith LCSCA forums hold an amazing amount of valuable information. Dr. Drew Hause at the Double Gun and the LCSCA site also shows the results of excess pressure, barrel obstructions, and heavy loads in both Damascus, Bernard, twist steel AND fluid steel "modern" shotgun barrels: caveat pressures. Makes one almost check bores after every brace of ducks, grouse, dove or clays. |
||||||
The Following 3 Users Say Thank You to henderson Marriott For Your Post: |
|
|