Parker Gun Collectors Association Forums  

Go Back   Parker Gun Collectors Association Forums Non-Parker Specific & General Discussions General Discussions about Other Fine Doubles

Notices

Reply
Thread Tools Display Modes
Unread 03-08-2013, 10:03 AM   #11
Member
Jack Selman
PGCA Lifetime
Member

Member Info
 
Join Date: Sep 2010
Posts: 104
Thanks: 210
Thanked 45 Times in 25 Posts

Default

My Philly Fox SW, bought several years ago from Ivory Beads' Jim and Jerry, ranks up there with my Parker Repro 20 as far as handling goes. Light and tight, it will serve all day in the woods and chasing clays. No disrespect to the Ithacas. Made American is what it's all about!
Jack Selman is offline   Reply With Quote
Unread 03-08-2013, 10:06 AM   #12
Member
BRDHNTR
PGCA Lifetime
Member

Member Info
 
Join Date: Nov 2012
Posts: 3,877
Thanks: 7,759
Thanked 2,891 Times in 1,308 Posts

Default

I think you're correct about the frame David. I should have taken my camera yesterday when I last looked at this 20ga fox sw. The shop owner practically grabbed me by the arm as I was leaving to make an offer, "any reasonable offer". I had the gun apart as I wanted to look it over well and was telling him how disappointed I was that the previous owner had blued the receiver. We'll see.
allen newell is offline   Reply With Quote
Unread 03-08-2013, 10:14 AM   #13
Member
OH Osthaus
PGCA Lifetime
Member
 
Rick Losey's Avatar

Member Info
 
Join Date: Jul 2010
Posts: 7,884
Thanks: 1,720
Thanked 8,381 Times in 3,310 Posts

Default

the bluing is most likely a cold blue - it will wear off quickly with use, and Birchwood Casey makes a cold blue remover if it botheres you too much.

personally - IMHO - the Fox is a much better gun. There is a reason Ithaca went to the NID to compete.

that price isn't bad - a 20 Sterlingworth without issues would go for much more in an area where doubles sell. I have looked at a couple lately in that same range. One was a 26" poorly restocked with old Bishop wood. the other was 28" and had some finish/wear issues but was on face. If this shop doesn't move doubles easily he may well bargin on it.
__________________
"If there is a heaven it must have thinning aspen gold, and flighting woodcock, and a bird dog" GBE
Rick Losey is offline   Reply With Quote
The Following User Says Thank You to Rick Losey For Your Post:
Unread 03-08-2013, 11:37 AM   #14
Member
Tony Ambrose
Forum Associate
 
Tony Ambrose's Avatar

Member Info
 
Join Date: Jan 2013
Posts: 48
Thanks: 181
Thanked 45 Times in 18 Posts

Default

Allen - buy it. You will not regret having a little SW 20 with 26" barrels. As recommended, grab some BC remover if you need immediate gratification, but it probably will wear quickly.

What else can you find for under $1000 that would bring the kind of satisfaction that you'll get from that little Fox? Not much in my opinion. And given that they were the Fox bargain gun.....essentially an "everyman's shotgun", it is an amazingly well built piece that takes a beating and keeps on ticking!
Tony Ambrose is offline   Reply With Quote
The Following 2 Users Say Thank You to Tony Ambrose For Your Post:
Unread 03-08-2013, 11:59 AM   #15
Member
Cold Spring
PGCA Member

Member Info
 
Join Date: Jun 2009
Posts: 2,036
Thanks: 3,711
Thanked 6,713 Times in 1,309 Posts

Default

Allen, I don't remember seeing the gun post on the Fox site and if I missed it this could be redundant. The serial number you cited is certainly a Sterlingworth number but the factory was doing some funky things to survive in the late 1930's. Fox SP/SPE Grade guns were made with blued frames and somewhat different barrel breech dimensions and are quite rare. The blued frame on the gun you're looking at, with everything else looking original, sounds odd and intriguing to me. It's also know that Savage execs had some leeway to get special features done on production guns. You might check the frame bar (water table) to see if "SP" is stamped anywhere. This is a very very long shot but if it turns out you'll want to go buy a megalotto ticket too. Frank
Frank Srebro is offline   Reply With Quote
The Following 2 Users Say Thank You to Frank Srebro For Your Post:
Unread 03-08-2013, 12:35 PM   #16
Member
Researcher
PGCA Lifetime
Member
 
Dave Noreen's Avatar

Member Info
 
Join Date: Jun 2009
Posts: 3,716
Thanks: 1,743
Thanked 8,187 Times in 2,454 Posts

Default

When Ithaca introduced the Flues Model in 1909, they were making their smallbore very light and delicate.



These are the guns often seen with cracked frames.

These guns were probably fine with the light 2 1/2 inch shells they were designed for, but North American Nimrods of the more is better ilk were for sure stuffing the heaviest loads they could buy in these little wands, and Ithaca saw they had a problem. By the mid-1920s, Ithaca had beefed up their Flues doubles quite a bit. In the 1912 through at least 1915 Ithaca catalogues they give their smallbore weights as --

16-ga 5 3/4 to 6 1/4
20-ga 5 1/4 to 5 3/4
28-ga 4 3/4 to 5 1/4

In the July 1919, Ithaca catalogue --

16-ga 5 lbs. 14 ozs. to 6 1/2
20-ga 5 1/2 to 6
28-ga 5 to 5 1/2

In the December 1, 1919, Ithaca catalogue --

16-ga 6 to 6 3/4
20-ga 5 3/4 to 6
28-ga 5 1/4 to 5 3/4

In the 1925 Ithaca catalogue --

16-ga 6 1/4 to 6 3/4
20-ga 6 to 6 1/2
28-ga 5 3/4 to 6 1/4

Savage didn't actually begin stating their Fox doubles were chambered for 2 3/4 inch shells until the second printing of the brown "art deco" Fox catalogue, usually found with 1938 or 1939 Retail Price sheets --



From about 1939, the Savage built Fox doubles were stamped on the left barrel --



This stamp is also found on Fox doubles of any vintage that were sent back to Savage for service and rechambered to 2 3/4 inches and reproofed.
Dave Noreen is offline   Reply With Quote
The Following 3 Users Say Thank You to Dave Noreen For Your Post:
Unread 03-08-2013, 01:39 PM   #17
Member
BRDHNTR
PGCA Lifetime
Member

Member Info
 
Join Date: Nov 2012
Posts: 3,877
Thanks: 7,759
Thanked 2,891 Times in 1,308 Posts

Default

The Ithaca Flues 20 ga that I have is ser# S377944 which is 1924 vintage. It is rugged for a little 20 and in excellent condition.

Frank, when I'm next at that gunshop, I'll check the water table to see if 'SP' is stamped on the table. I don't win much with $1 scratch tickets so I don't bother with the mega lottery!
allen newell is offline   Reply With Quote
Unread 03-08-2013, 10:50 PM   #18
Member
Harold Pickens
PGCA Member
 
Harold Lee Pickens's Avatar

Member Info
 
Join Date: Mar 2011
Posts: 3,765
Thanks: 2,224
Thanked 8,284 Times in 2,111 Posts

Default

Can you imagine one of the utility grade guns of today, such as the CZ, Huglu, and others holding up for a hundred years like the Foxes, Parkers
,LC Smith, Lefever, and Ithacas. My friend got a new CZ sxs 20 for his son and it already has had 2 issues that necessitated it being returned for service.
The young man is a sxs fan, so I gave him the choice between borrowing one of my SW 20's or my Lefever Durston Special 20 w/ ejectors to use on his hunting trip. He chose the SW and he did it proud.
I think I would pick up that SW if I were you.
Harold Lee Pickens is offline   Reply With Quote
The Following 2 Users Say Thank You to Harold Lee Pickens For Your Post:
Unread 03-09-2013, 01:14 AM   #19
Member
Researcher
PGCA Lifetime
Member
 
Dave Noreen's Avatar

Member Info
 
Join Date: Jun 2009
Posts: 3,716
Thanks: 1,743
Thanked 8,187 Times in 2,454 Posts

Default

An SP-/SPE-Grade would be marked like this on the watertable --



The Savage Proof Mark is an SP in an oval --

Dave Noreen is offline   Reply With Quote
The Following User Says Thank You to Dave Noreen For Your Post:
Unread 03-09-2013, 09:54 AM   #20
Member
BRDHNTR
PGCA Lifetime
Member

Member Info
 
Join Date: Nov 2012
Posts: 3,877
Thanks: 7,759
Thanked 2,891 Times in 1,308 Posts

Default

Dave Noreen: The frame and foreend latching mechanisims on myy Ithaca Flues 20 ga double (1924) ser# 37944 look to be blued. Now, this gun belonged to an uncle of kine who gave it to me in the late 60's early 70's when he decided to stop hunting and I had returned from Viet Nam and needed a shotgun. It's been in my famly for most of these years except for a period of time when it was in the posession of a close friend (who did nothing with it at all). While it's possible that my dad may have cold blued it, I really doub it as he would have said something to me. I can find no trace of any case colors on this double, none on the watertable, fore end latching assemblies, top lever and tang etc. Is it possible that this gun could have come from the factory with a blued receiver and no case colors? It's a mystery to me.
allen newell is offline   Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 12:54 PM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright © 1998 - 2024, Parkerguns.org
Copyright © 2004 Design par Megatekno
- 2008 style update 3.7 avec l'autorisation de son auteur par Stradfred.