i just thought i had loaded a 3 inch 410 with 1 ounce of shot...i was using one of the old powder and shot measuring devices..turns out that 1 ounce of shot even though filled to the brim does not weigh 1 ounce using the shot measurement...i weighed thecontents of cup and it only weighed 3/4 ounce on scales...the shot measuring device is badly off by 1/4 ounce.. after putting correct amount of powder and very thin over powder card i filled the hull to the top then weighed the contents.. not hardly 7/8 ounce of shot... i retried this with no 9 shot and it weighed a little more than the no6s i was using. but still did not weigh 7/8 ounce... all said and done you can not put 1 ounce of shot in a 3 inch 410 hull with the correct powder load in it... only way to get 1 ounce in a 410 3 inch hull would be to leave out the powder..ha ive was wrong in saying that i had shot 1 ounce loads in a 410 no possible way to get that amount of shot in the hull..the shot measuring device was off by a lot so fellas i hope you check your shot measuring devices.. has anyone had this problem before.. bill you are right i will need to get me some longer cases or hulls to be able to shoot 1 ouce 410 loads...been trying to thinck how to lenthen plastic hulls but aint come up with any thing... any suggestions... charli
|