|
11-21-2021, 11:48 AM | #13 | ||||||
|
Reloader network 4 pin roll crimp tool IS the best. Now have one for each gauge. I have tried several others and will gladly mail them to anybody that wants to try them, I'll never use them again!
|
||||||
The Following User Says Thank You to Keith Doty For Your Post: |
11-21-2021, 06:34 PM | #14 | ||||||
|
Thats the only downside ive read on the hull trimmer is they dont sell new blades. I pulled these loads apart today and noticed in the high velocity loads Winchester only used a 1/4" fiber wad but for the low velocity a 1/2" fiber wad both of these are 2oz loads I believe seemed odd to use such thin wadding for the high velocity load.
|
||||||
11-21-2021, 06:38 PM | #15 | ||||||
|
I wish they made it in 8 gauge also, now in the UK there is a 2 pin one sold for the 8 ga but they cant export reloading supplies/equipment.
|
||||||
11-21-2021, 09:04 PM | #16 | ||||||
|
Blades for that trimmer are available from BPI, bought some recently.
|
||||||
11-22-2021, 05:21 AM | #17 | |||||||
|
Quote:
I just ordered about $250 in reloading supplies bought some 10 and 8 gauge components since I saw BPI had 10 gauge hulls back in stock . Ordered a Reloaders Network roll crimper for the 10 ga and some other items. Havnt bought shot yet still deciding what I want to load. |
|||||||
11-22-2021, 05:23 AM | #18 | ||||||
|
Thanks, on 10G I use the arbor press too & imperial die wax.
On trimming to length, 16 & 10 have a couple jigs to trim 4 at a time on the bandsaw no reason same thing would not work 8G. It’s just a wood block with holes, split with a wing nut to tighten. 4 set up run it through the saw using the rip fence. Thing about the twist and cut trimmers my wrist won’t last long twisting. After sawing the case mouth needs conditioning, do it in the drill press with another shop made tool also convertible to 8 G . Will see if I can find a photo to post William |
||||||
11-22-2021, 05:41 AM | #19 | ||||||
|
Here you go, from idea on the bottom to ones that work best top. Wood insert builds friction and heat faster. Any gauge, have made from 410 to 10, no reason 8 won’t work.
http://parkerguns.org/forums/picture...ictureid=11039 William |
||||||
The Following User Says Thank You to William Davis For Your Post: |
11-22-2021, 07:04 PM | #20 | |||||||
|
Quote:
|
|||||||
|
|