|
02-12-2013, 09:39 AM | #3 | ||||||
|
That's good advice. I will replace the top lever spring to get the "mushy" feel out of the lever. I don't like mushy, except with my peas.
|
||||||
02-12-2013, 10:47 AM | #4 | ||||||
|
Usually it does not take much wear to the left before the locking bolt face hits the lug. This is when the action becomes loose because the angle bite is no longer fully engaged.
__________________
B. Dudley |
||||||
02-12-2013, 01:26 PM | #5 | ||||||
|
If the gun's tight, shoot it until it isn't. Then worry about the top lever position.
Best, Kensal |
||||||
02-12-2013, 06:04 PM | #6 | ||||||
|
The only real concern with Parkers and a lever to the left but still tight is that the dish in the top will not line line up with the frame. This is an aesthetic matter of course.
__________________
B. Dudley |
||||||
02-12-2013, 08:42 PM | #7 | ||||||
|
Ed;
Just keep the lug lubed with a good grease to slow the wear. Or you could send it to me and I will evaluate it for the next few years and then give you my diagnosis on what you should do. |
||||||
The Following User Says Thank You to Daryl Corona For Your Post: |
02-15-2013, 09:20 AM | #8 | ||||||
|
Daryl you are a real pal.
|
||||||
02-15-2013, 12:18 PM | #9 | ||||||
|
I have had the pleasure of disassembling three Parker top lever guns and made the following observation.....based on the shape of the top lever and its orifice in the receiver, the top lever (on my guns, anyway) could not swing to the left past center. It is physically impossible. After years of snapping the action shut, I could see where metal on the receiver and lever could be peened enough to allow the lever to go past center. The levers on my three guns are firmly centered, but the other components of the locking mechanism are worn to varying degrees. The spring still firmly drives the bolt into the barrel lug, thus locking the action properly.
__________________
GMC(SW)-USN, Retired 'Earnest Will' 'Desert Shield' 'Desert Storm' 'Southern Watch' |
||||||
02-15-2013, 01:38 PM | #10 | ||||||
|
Pre bolt plate guns commonly go past center. I don't mess with them. I have a gun or two that are not tight when closed. If I could find someone to put a nice shim at the bottom of the slot, I would have them do it and I would file it in. I don't think it is the easiest place to install a .002 shim.
|
||||||
|
|