Ejectors? And 10Ga Questions?

[B. Dudley]

Originally Posted by DuggerWebster

Nice! So should I assume this one is 12ga at 2-7/8 shells or 2-1/2?

Measure the chambers.

[Larry the Gun Guy]

So, does the hammer gun have 32" barrels or have they been shortened?
And then, what's the serial number and barrel length on the other gun?

[6pt-Sika]

Originally Posted by Larry Stauch

So, does the hammer gun have 32" barrels or have they been shortened?
And then, what's the serial number and barrel length on the other gun?

Hammer gun #51221 is listed as 30” .

[6pt-Sika]

Originally Posted by DuggerWebster

Nice! So should I assume this one is 12ga at 2-7/8 shells or 2-1/2?

I’d assume it was 2 5/8” and since it’s Damascus I’d shoot nothing heavier than something like RST 1 1/8 ounce loads maybe a 1 1/4 ounce load if they make one that isn’t stout .https://www.rstshells.com/store/c/3-12-Gauge.aspx

[DuggerWebster]

Will have to measure those barrels later.. serial number is 51221

[DuggerWebster]

OK.. Back at the office.. Wanted to say thank you again to All before I close it out.