|
 |
 |
||||||||||||||||||||||||||||||||||||||
Visit Mike Koneski's homepage! | | ||||||||||||||||||||||||||||||||||||||
 |
 |
Today, 09:24 AM
|
#3 | ||||||
|
other far less expensive options....
|
||||||
|
|
||||||
 |
 |
 |
| The Following User Says Thank You to randall rosenthal For Your Post: |
|
|
|
Today, 11:46 AM
|
#4 | ||||||
|
I have looked and bought shells but a limited supply as stated.I'm not complaining just inquiring if anyone has any inside knowledge.Five years ago they were stocked and at the Southern SXS with a full trailer.Now limited stock I would think components would be available now.Most other suppliers and manufacturers are.Cost is a whole other issue.
|
||||||
|
|
|
||||||
|
|
|
| The Following 2 Users Say Thank You to Bob Hayes For Your Post: |
|
|
|
Today, 03:16 PM
|
#5 | ||||||
|
How dependent were RST recipes on Alliant or other hard to impossible to get powders? Many Remington wads are also not available. Things are far from the pre Covid days when it comes reloading components.
__________________
Progress is the mortal enemy of the Outdoorsman. |
||||||
|
|
|
||||||
|
|
|
| The Following 2 Users Say Thank You to Pete Lester For Your Post: |
|
|
|
Today, 05:46 PM
|
#6 | ||||||
|
Randall, what are the pressure levels of the shells you picture? Morris Baker and RST claims lower pressures suitable for composite barrels. Other makers of short shells with light shot loads do not make those claims.
|
||||||
|
|
|
||||||
|
|
|
| The Following User Says Thank You to Bill Murphy For Your Post: |
 |
|
|
Linear Mode
