|
CHE |
Today, 09:38 AM | #13 | ||||||
|
CHE
I may just drill out most of center which should relieve any possible pressure in future. Thanks.
|
||||||
Today, 10:54 AM | #14 | ||||||
|
I have seen two stocks split that had lead plugs in them. Not sure I would bet on drilling the center out, as it is the oxidation on the outside of the lead plug against the wood that causes the expansion.
__________________
Keavin Nelson |
||||||
The Following 3 Users Say Thank You to keavin nelson For Your Post: |
Today, 01:10 PM | #15 | ||||||
|
Yup, after drilling out as much of the center as possible, drill a hole that includes an edge of the plug as well as a bit of wood, leaving room for the plug to move.
|
||||||
The Following User Says Thank You to Bill Murphy For Your Post: |
|
|