![]() |
![]() |
![]() |
|||||||||||||||||||||||||||||||||||||
|
![]() |
![]() |
![]() |
#3 | ||||||
|
![]()
Thanks Dean
62698 15700 |
||||||
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
#4 | ||||||
|
![]()
Tom, this chart will help you out.
|
||||||
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
#5 | ||||||
|
![]()
Your two 12 gauge guns could easily have .750 original bores. Early tens often have bores of .790 or .800. Austin Hogan and I determined through much empirical research that some later guns, especially single trap guns, have original bores as large as .740.
|
||||||
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
#6 | ||||||
|
![]()
Ok thanks guys
I feel better about them, I just assumed they were reamed and honed to clean them up before they were sold. I have an awful lot to learn on these things. Thanks, Tom |
||||||
![]() |
![]() |
![]() |
![]() |
![]() |
![]() |
Thread Tools | |
Display Modes | |
|
|