|
 |
 |
||||||||||||||||||||||||||||||||||||||||
Visit Brian Dudley's homepage! | | ||||||||||||||||||||||||||||||||||||||||
 |
 |
02-08-2017, 10:39 PM
|
#3 | ||||||
|
Reminds me of a sign a man had on his table at OGCA - "How come all my stuff is sh*t, and your sh*t is stuff?"
__________________
"Striving to become the man my dog thinks I am" |
||||||
|
|
||||||
 |
 |
 |
|
|
|
02-09-2017, 03:48 PM
|
#4 | ||||||
|
Sorry guys it was to good to pass up.
|
||||||
|
|
|
||||||
|
|
|
|
|
|
02-25-2017, 05:37 PM
|
#5 | ||||||
|
I received the above mentioned gun today. I tried to check the bore diameter with my Skeets gauge but it doesn't appear to go large enough. Did they make a gauge specifically for the 10 gauge? The instruction sheet gives a nominal bore dia. of .775 for a 10ga. The gauge went up to about .782 but it would still rattle around inside the bore so I couldn't get an accurate reading. The constriction on each barrel was about .765
Do you think that since the gun was ordered to shoot extra close that it would have had a larger than normal bore diameter for some reason?? |
||||||
|
|
|
||||||
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode