12ga GHE 30" Vent Rib

[Reggie B]

Bill I know you like to read, so here is a thread that discusses this topic--

https://parkerguns.org/forums/showth...=doll%27s+head

[Dean Romig]

Tightening the hook to the roll pin could have caused the gaps at the doll’s head.





.

[J. Scott Hanes]

The Identification & Serialization book does not list either the VR or the SST; only that is was ordered with a second set of barrels. Of course, the 'book' is not always accurate. As for the serial # under the rib, I found the number on the VR DHE I recently bought at the very rear of the rib, barely visible, after looking in the normal location.

[Don Anderson]

Thank you all for the observations and evaluations. When I first handled this gun, it seemed entirely too tight for it's vintage, so I suspect it has been reworked at some point. I'm not too far from Ellijay GA, so I'm going to get Bill Schwarz to give this one and the 20ga VH I bought a once over.
If the entire gun has been worked over, it won't hurt my feelings as I purchased both guns at a local shop for less than I see some tired old 12ga Trojans selling for.


More pictures for further evaluation and re some of the above questions.

[Don Anderson]

[GunnerGrilli]

Originally Posted by Dean Romig

That thing’s got some chokes!!!




.

Choke for Smoke Baby!!!


Nice gun, enjoy it.



Bobby

[Don Anderson]

Originally Posted by GunnerGrilli

Choke for Smoke Baby!!!


Nice gun, enjoy it.



Bobby

Thanks. I plan to give it a try in the next day or 2 on the local 5 stand. Selective trigger and ejectors check out on snap caps, but I'll single load with a snap cap in the other chamber until I determine that it doesn't have an issue with doubling. I normally shoot a pretty mild 7/8oz hand load for sporting clays which should work well. It seems to fit me pretty well.