|
 |
 |
|||||||||||||||||||||||||||||||||||||
| ||||||||||||||||||||||||||||||||||||||
 |
 |
10-14-2015, 08:39 PM
|
#13 | ||||||
|
I don't like Rem Oil at all... It doesn't stay. Almost like it "beads up".
.
__________________
"I'm a Setter man. Not because I think they're better than the other breeds, but because I'm a romantic - stuck on tradition - and to me, a Setter just "belongs" in the grouse picture." George King, "That's Ruff", 2010 - a timeless classic. |
||||||
|
|
||||||
 |
 |
 |
|
|
|
10-14-2015, 10:41 PM
|
#14 | ||||||
|
If you can find it, real sperm oil works well to liquefy proud rust but doesn't seem to harm bluing. I just dab it on with a fingertip and leave it there as long as you can. (sometimes for a week) Then I use the Frontier 45 pad to wipe it off. It sort of looks muddy before you wipe it off...
|
||||||
|
|
|
||||||
|
|
|
| The Following 2 Users Say Thank You to John Cinkoske For Your Post: |
|
|
|
10-15-2015, 07:47 AM
|
#15 | ||||||
|
If I find any surface crud on my guns, I'll spray a little G96 on a Frontier Pad and scrub it off. When I'm cleaning the interior of barrels after a shoot, I'll spray G96 on the brush which also has a few strands of a Frontier Pad wrapped around the bronze brush, then scrub the interior surfaces before running the patches through. One can not say enough about Frontier Pads for cleaning interior/exterior surfaces without harm. I prefer G96 over all other cleaning agents (I don't find this stuff in too many places) as it cleans without harming case colors or blued surfaces. My experience only.
|
||||||
|
|
|
||||||
|
|
|
| The Following User Says Thank You to allen newell For Your Post: |
|
|
|
10-15-2015, 07:10 PM
|
#16 | ||||||
|
I don't think Hoppes No.9 would be around for nearly a hundred years if it removed bluing. I can believe it might stain or have some effect on cold bluing (Birchwood Casey or Brownells Oxpho Blue), but not cold rust bluing, hot bluing, or nitre bluing.
|
||||||
|
|
|
||||||
|
|
|
| The Following 2 Users Say Thank You to edgarspencer For Your Post: |
|
|
|
10-15-2015, 08:39 PM
|
#17 | ||||||
|
Just got a new bunch of Frontier pads. They're selling a new lube/cleaner/protectant called Safari Charlie so I ordered a bottle. Just tried it on a 1 frame 16 project and it did a good job. I still use WD-40 when I'm serious with the rust. Safari Charlie cuts the hardened gunk right out of screw slots but haven't used it long enough to see it's full potential.
Big45metalcleaner.com is the website. Joe |
||||||
|
|
|
||||||
|
|
|
| The Following User Says Thank You to Joe Dreisch For Your Post: |
|
|
|
10-26-2015, 10:33 AM
|
#18 | ||||||
|
Edgar, we won't be around for a hundred years, must be something wrong with us! LOL
|
||||||
|
|
|
||||||
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
