Dry firing a hammer Parker

[edgarspencer]

Originally Posted by Rich Anderson

Take the forarm off an ejector gun thats not cocked to put it in a gun case and you won't make that mistake again

You've said this before, and it made no more sense this time than when you said it the first time. The ejectors will remain cocked when you take you fore end off, unless there's a mechanical issue that's making them trip. I have no issues with ANY of my ejector guns, Parker or otherwise.

[C.O.B.]

Bring one of your ejector guns to the Southern and I'll demonstrate for you.

[edgarspencer]

I'm not going to the Southern.
I can fire both hammers, remove the fore end, remove the barrels, replace the barrels, snap the fore end right back on, open the gun and the ejectors trip as they normally would. I can do this on each and every ejector gun I own.
It there is something wrong with the gun, and the ejector hammers are firing when the gun is fired, before opening the gun, or if they are tripping when you remove the fore end, you need to make a trip to the smithy.
If I'm misunderstanding what you're saying, tell me what I don't get. As I recall, when you brought this up before, all the other posters replied that they had no issues removing and replacing the fore end on a gun when the hammers were down.

[Smoothebore]

If it's an underlifter with offset firing pins you purchased from me, then fire away, they will not break, I guarantee it.

[Bindlestiff]

C.O.B.

I'm with Edgar on this one. I too have been wondering if I have missed something when you say they are an issue to get back on. I always drop the hammers to relieve the spring tension on the hammers. I take the barrels off afterwards and reassemble with no issues. My guns disassemble and assemble just fine with or without the hammers cocked.

[Bindlestiff]

OK.