Stock length

[edgarspencer]

I just measured an original 0 sized butt plate at 4 13/16", tip to tip.
Bill, I've never seen a 12 bore with an 0 sized butt. That had to be special ordered. Was is mentioned in the order book? I do have a 16 with an 0 sized butt, and also one with a 1 sized butt. I always assumed my 0 sized (0 frame) 16 was either switched with a 20 ga. butt, but I suppose it's possible it was special ordered also. Does you gun with the smaller-than 0 butt have a pad or SSBP?

[Autumn Daze]

I don't think butt sizes were written in stone so to speak. The size selected was all part of the weight/balance equation.

[edgarspencer]

There may have been more latitude in padded butts or skeleton steel butt plates, however there isn't that much border around the hard rubber plates that can be sanded/ground/milled (or whatever) down from the standard molded plates. So are you suggesting that there were others than the ones with a 0, 1, 2 molded into the back side?

[Labowner]

Rich, Galco has a extra small slip on pad, I have all five from extra small to the extra large for the Ten.